This step is also demoed with this video :

(ongoing...)

Step 1c : Remove modules from the assembly from the source Models

From previous step 1b, we've seen how to copy modules to an assembly from a Simulink model using the model synchro functionality.

This step 1c focuses on how to remove modules from an assembly while synchronizing it with its attached Simulink model :

As we can see, in this context :

we would like to remove module FB_YawRate_v003d000 from the assembly. As explained in step 1a, this can be done using the cross button.

This can be done too while synchronizing, press Sync Smk button :

As a module of an assembly is selected, the Remove button get enabled and can be used.

Since in this case, FB_YawRate_v003d000 was the only one, there is no more module in the assembly listed in the left table :

which is of course the same in the ABL view too :

Last action of synchronization that has to be explained is the copy to a Simulink model :

This is the purpose of next step 1d.

Published with MATLAB® R2013a