This step is also demoed with this video :

(ongoing...)

Step 2f : Towards not empty architecture

Previous steps showed use of assemblies dealing with specific zones of the initial Simulink model,

and more specifically :

• • abl_targets_v000d000 for the targets zone

  • abl_measurements_v000d000 for the measurements zone including analog and can decoding zone

  • abl_FB_v000d000 for the feedback control zone

  • monitoring zone has been left as it

This lead to this Simulink model including these 3 assemblies :

Next step could be to manage all these modules inside a unique assembly :

These modules could be assembled inside an empty architecture, as it was the case so far.

But it can be more convenient to organize modules in an architecture that has to be designed.

A simple sketch could be :

Following steps deal with auto assembly upon not empty architectures :

• • next Step 3 shows auto assembly upon different architectures in order to organize feedback, measurement, etc...

  • Step 5 specifically focus on how to design an architecture

Published with MATLAB® R2013a